Hydraulic destroyers, demolition, tracked excavators, wheel loaders, earthmoving machinery, earthmoving machineries, hydraulic hammers, demolition hammers, Hydraulic demolition hammers, mini excavators, earthmoving, perforations, demolition crushers, cracking jaws, breaker crushers, hydraulic crushers, backhoe  
 
Monobloc body
Hydraulic brake failed blows
N2 energy system
Insonorized
Counterpressure
Streamline shape
Protected pipe links
 
 
 
2009 year model is equipped with a new "CPS" valve that allows the hammer to work with much higher counter pressure. With new case, the level of noisiness has been reduced. The visibility thanks to the new rounded shape still turns out improved.
Renewal of our range, today sees the introduction of three new ones demolishers: S400, S550 and S800.
  
 


The special monobloc manufacture, confer to the steel frame a high resistance at the effort of leverage
so frequent during work. The hammer is built from a single piece without tie-rod, so removing a very
common problem in conventional hammer.


To avoid that working the failed blows reverberating on the structure, it was conceived a special hydraulic
brake that reduce the power out of 60 % when the point is not on the material to demolish.
It is unchannged the possibilityto pull down little protuberances from the wall with full power.

..
Our breakers work utilizing inertial n2 energy recuperation system. The Nitrogen gas operating system
give to the hammer a lot of power and reduces solicitations to the excavator hinged arm.


In the past, the breakers with n2 energy recuperation system, needed frequent recharge.
With our new S series, using special gas ring on floating bearing, we increasing out of 300 % the n2 life
charge.


Our breaker, with monobloc body in association with shut framewerk and sound absorbent material
insertion,has permitted to reach sound emissions level very low. In heavy condition, the cooling is
guaranteed by internal labyrinth with thermosiphon effect.


The S series is designed to withstand extremely high counter-pressure and widesetting range of the oil
flow in order to facilitate the installation.


Series S hammers, with their particular tapered shape, guarantee a very good visual during work and
allow to operate very close to the walls.